Suzuki Wagon R Manual page 232

7) Set new differential side small band (2) and differential side
boot (1) on shaft temporarily.
8) Apply grease to DOJ and inside of housing.
Use grease supplied with spare parts.
"A": Thermax grease/Color: Black
Grease capacity: About 50 – 70 g (1.8 – 2.5 oz)
9) Place DOJ onto spline of drive shaft and drive onto drive shaft
by using plastic hammer until retaining ring engages.
10) Fit boot to grooves of shaft and housing and adjust length "d"
to specification below.
Insert screwdriver into boot and allow air to enter boot so that
air pressure in boot becomes the same as atmospheric pres-
sure.
Length "d": 80 – 90 mm (3.15 – 3.54 in.)
CAUTION:
Differential side
D To prevent any problem caused by washing solution,
D Do not squeeze or distort boot when fastening it with
11) Install and fasten new big and small bands at that position of
step 10) in the same procedure as steps 6) to 9) of Tripod Joint
Type Drive Shaft Assembly.
For Center shaft and Center bearing support
Install center shaft by reversing removal procedure and noting fol-
lowing points
D When installing bearing support circlip (1), make sure that it fits
in circlip groove in center bearing support (2) securely as shown.
do not wash joint boots. Degreasing of those parts
with cloth is allowed.
bands.
Distorted boot caused by squeezing air may reduce
its durability.
FRONT DRIVE SHAFT 4-11