Suzuki Wagon R Manual page 297

Hide thumbs Also See for Wagon R:
Table of Contents

Advertisement

5C-14 PARKING AND REAR BRAKE
INSPECTION
Inspect wheel cylinder disassembled parts for wear, cracks, corro-
sion or damage.
NOTE:
Clean wheel cylinder components with brake fluid.
INSTALLATION
1) Take off bleeder plug cap from brake pipe and connect pipe (for
pipes) to wheel cylinder just enough to prevent fluid from leak-
ing.
2) Tighten wheel cylinder (1) to brake back plate (2) to specified
torque.
3) Torque flare nut (3) of brake pipe (4) which was connected in
step 1) to specification.
Tightening Torque
.
(a): 12 N
m (1.2 kg-m, 9.0 lb-ft)
.
(b): 16 N
m (1.6 kg-m, 12.0 lb-ft)
4) Install bleeder plug cap taken off from pipe back to bleeder plug.
5) For procedure hereafter, refer to steps 1) to 6) of BRAKE SHOE
INSTALLATION.
NOTE:
Be sure to bleed brake system. (for bleeding operation, see
BLEEDING BRAKES in SECTION 5.)
BRAKE BACK PLATE
REMOVAL
1) Perform steps 1) to 5) of BRAKE DRUM REMOVAL in this sec-
tion.
2) Perform steps 2) to 4) of BRAKE SHOE REMOVAL in this sec-
tion.
3) Perform steps 3) and 4) of WHEEL CYLINDER REMOVAL in
this section.
4) Remove parking brake cable securing clip (1) and disconnect
brake cable (2) from brake back plate (3).

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents