Suzuki Wagon R Manual page 228

1
2
3
2) Remove DOJ from shaft as follows.
a) Fold over boot and remove old grease so that retaining ring
(1) is accessible.
b) Clamp drive shaft in soft jawed vise.
Spread retaining ring using snap ring pliers (opening type)
and tap DOJ of drive shaft using plastic hammer until retain-
ing ring no longer engages in groove of shaft.
3) Remove snap ring (1) and then remove cage (2) with retaining
ring (3) from housing (4) if necessary.
4) Remove differential side boot, damper and wheel side boot from
shaft referring to steps 5), 6), 7) and 8) in disassembly for tripod
joint type drive shaft.
For Center shaft and Center bearing support
1) Using hydraulic press (1), draw out center shaft (2) from center
bearing.
2) Remove oil seals from center bearing support (3).
3) Remove bearing support circlips (1).
Special Tool
(A): 09900-06108
4) Remove center bearing from center bearing support.
FRONT DRIVE SHAFT 4-7