Suzuki Wagon R Manual page 166

7) Remove contact coil cable assembly (1) from steering column.
INSPECTION
Check contact coil cable assembly wire harness for any signs of
scorching, melting or other damage. If it is damaged, replace.
INSTALLATION
1) Check to make sure that vehicle's front tires are set at straight-
ahead position and then ignition switch is at "LOCK" position.
2) Install contact coil cable assembly (1) to steering column se-
curely.
NOTE:
New contact coil cable assembly is supplied with contact
coil set and held at its center position with a seal (2). Peel
this seal after installing contact coil cable assembly to
steering column.
3) Connect connector (1) for contact coil cable assembly by push-
ing connector lock (2) into connector.
STEERING WHEEL AND COLUMN 3C-13