Suzuki Wagon R Manual page 334

1. Sensor terminal
2. Sensor body
REMOVAL
1) Disconnect negative cable from battery.
2) Disconnect front wheel speed sensor coupler (1).
1
3) Hoist vehicle and remove wheel.
4) Remove harness clamp bolts (2) and grommet (3).
5) Remove front wheel speed sensor (4) from knuckle.
4
SENSOR INSPECTION
D Check sensor for damage.
D Check sensor for resistance and continuity.
Between both terminals (1) sensor: 1.2 – 1.6 kΩ at 20_C
Between sensor terminal and sensor body (2): No continuity
If the check result is not as specified and any malcondition is
found, replace.
INSTALLATION
1) Check that no foreign material is attached to sensor (1) and sen-
sor ring (2).
2) Install it by reversing removal procedure.
Tightening Torque
(a): 10 N
3) Check that there is no clearance between sensor and knuckle.
CAUTION:
D Do not pull wire harness when removing front wheel
speed sensor.
D Do not cause damage to surface of front wheel speed
sensor and do not allow dust, etc. to enter its installa-
tion hole.
.
m (1.0 kg-m, 7.5 lb-ft)
CAUTION:
Do not pull or twist wire harness more than necessary
when installing front wheel speed sensor.
ANTILOCK BRAKE SYSTEM (ABS) 5E1-33
(68_F)