Suzuki Wagon R Manual page 256

Refer to Section 5 BRAKES.
Refer to Section 5 BRAKES.
CAUTION:
D Lubricate rubber parts with clean, fresh brake fluid to ease assembly.
D Do not use lubricated shop air on brake parts as damage to rubber components may result.
D If any hydraulic component is removed or brake line disconnected, bleed the brake system.
D The torque values specified are for dry, unlubricated fasteners.
D Do not allow brake fluid to get on painted surfaces. Painted surfaces will be damaged by brake fluid.
FRONT BRAKE HOSE/PIPE
REMOVAL
1) Raise and suitably support vehicle. Remove tire and wheel.
This operation is not necessary when removing pipes connecting master cylinder and flexible hose.
2) Clean dirt and foreign material from both hose end or pipe end fittings. Remove brake hose or pipe.
INSTALLATION
1) Reverse removal procedure for brake hose and pipe installation procedure.
For installation, make sure that steering wheel is in straightforward position and hose has no twist or kink. Check
to make sure that hose doesn't contact any part of suspension, both in extreme right and extreme left turn condi-
tions. If it does at any point, remove and correct. Fill and maintain brake fluid level in reservoir. Bleed brake sys-
tem.
2) Perform brake test and check installed part for fluid leakage.
DIAGNOSIS
CHECK AND ADJUSTMENT
ON-VEHICLE SERVICE
BRAKES PIPE / HOSE / MASTER CYLINDER 5A-3
1. E-ring:
Insert E-ring till its
end surface is flush
with or deeper than
bracket end surface.
2. Flexible hose
3. Hose washer
4. Hose bolt
5. Brake caliper
: Tightening Torque
: Do not reuse