Suzuki Wagon R Manual page 178

1. Split pin 6. Stabilizer bar
2. Castle nut 7. Mount bushing
3. Stabilizer bar washer 8. Mount bush bracket
4. Stabilizer bar bushing 9. Mount bracket bolt
5. Suspension control arm
ON-VEHICLE SERVICE
STABILIZER BAR AND/OR BUSHINGS
REMOVAL
1) Hoist vehicle and allow the front suspension control arms (5) to
hang free.
2) Remove front wheels.
3) Remove split pins (1) and then castle nuts (2).
4) Remove stabilizer bar mount bushing bracket bolts (9).
5) Remove stabilizer bar (6) from front suspension control arms
(5).
NOTE:
If it is hard to remove stabilizer bar (6), set tires in contact
with ground (with suspension compressed).
: Tightening Torque
: Do not reuse
INSTALLATION
For installation, reverse removal procedure, observing the follow-
ing instructions.
D Install stabilizer bar (1) so that paint mark (2) on it comes to the
right side of vehicle.
D Align the outside edge (1) of mount bushing with the inside edge
(2) of paint as shown in figure.
FRONT SUSPENSION 3D-5