5A-12 BRAKES PIPE / HOSE / MASTER CYLINDER
BRAKE BOOSTER
CAUTION:
D Never disassemble brake booster. Disassembly will spoil its
original function. If it is found faulty, replace it with new one.
D Observe CAUTION at the beginning of ON-VEHICLE SER-
VICE.
REMOVAL
1) Remove master cylinder assembly, referring to steps 1) to 5) of
its REMOVAL in this section.
2) Disconnect brake vacuum hose from brake booster.
3) Disconnect push rod clevis (1) from brake pedal arm (2).
4) Remove attaching nuts (3) and then booster.
INSPECTION
D Check brake booster for damage and operation, boot for damage
and deterioration.
D Check for push rod length.
Length
"a": 114.5 – 115.5 mm (4.51 – 4.55 in.)
If any malfunction is found, replace brake booster.
1. Brake master cylinder assembly
2. Brake booster assembly
3. Gasket
4. Push rod clevis
5. Nut
6. Clevis pin:
Apply SUZUKI SUPER GREASE A
99000-25010 to clevis pin.
7. Clip
8. Nut
9. Brake vacuum hose
: Tightening Torque
: Do not reuse