Suzuki Wagon R Manual page 162

2
Check air bag (inflator) module visually and if any of the following
is found, replace it with a new one.
D Air bag being deployed
D Trim cover (pad surface) (1) being cracked
D Terminal (2) being damaged
D Air bag (inflator) module being damaged or having been exposed
to strong impact (dropped)
INSTALLATION
1) Connect yellow connector (1) of driver air bag (inflator) module
and then lock (2) securely as shown in figure.
2) Install driver air bag (inflator) module to steering wheel, taking
care so that no part of wire harness is caught between them.
3) Tighten driver air bag (inflator) module mounting bolts (1) to spe-
cified torque.
Tightening Torque
.
(a): 10 N m (1.0 kg-m, 7.5 lb-ft)
4) Make sure that clearance between module and steering wheel
is uniform all the way.
5) Connect negative battery cable.
6) Enable air bag system. Refer to "Enabling Air Bag System" un-
der "Precautions" earlier in this section.
STEERING WHEEL AND COLUMN 3C-9