Suzuki Wagon R Manual page 332

(a)
RH
LH
INSTALLATION
1) Install hydraulic unit by reversing removal procedure.
Tightening Torque
.
(a): 16 N m (1.6 kg-m, 11.5 lb-ft)
.
(b): 9 N m (0.9 kg-m, 6.5 lb-ft)
.
(c): 9 N m (0.9 kg-m, 6.5 lb-ft)
.
(d): 26 N m (2.6 kg-m, 18.0 lb-ft)
2) Bleed air from brake system referring to "BRAKE" section.
3) Check each installed part for fluid leakage and perform "ABS Hy-
draulic Unit Operation Check" in this section.
NOTE:
For new ABS hydraulic unit/control module assembly, if
"ABS Hydraulic Unit Operation Check" procedure has not
been performed, "ABS" warning lamp may flash when igni-
tion switch is turned ON position.
ANTILOCK BRAKE SYSTEM (ABS) 5E1-31