WHEEL BEARING AND WHEEL STUD
REMOVAL
1) Remove rear brake drum, referring to REAR BRAKE DRUM RE-
MOVAL in SECTION 5C.
2) Remove circlip (1).
Special Tool
(A): 09900-06108
3) Remove wheel bearing by using special tool and hydraulic
press.
Special Tool
(A): 09913-76010
CAUTION:
Never reuse wheel bearing.
Reused bearing should have excessive play.
4) Remove wheel stud bolt by using hydraulic press (1).
INSTALLATION
1) Insert new stud in drum hole and rotate it slowly to assure serra-
tions are aligned with those made by replaced bolt.
2) Install new wheel bearing (1) by using special tool and hydraulic
press.
NOTE:
Seal side of bearing comes inside of brake drum.
Special Tool
(A): 09913-75810
REAR SUSPENSION 3E-19