Suzuki Wagon R Manual page 249

5-14 BRAKES
3) Depress brake pedal gradually till fluid pressure of front brake
becomes as specified below and check corresponding pressure
of rear brake then. It should be within specification given below.
Front brake
7,500 kPa
2
75 kg/cm
1,067 psi
As done above, apply 100 kg/cm
check that rear brake pressure then is within specification as giv-
en below.
Front brake
10,000 kPa
2
100 kg/cm
1,422 psi
4) If rear brake pressure is not within specification, adjust it by
changing spring bracket (2) position as follows.
D If rear brake pressure is higher than specification, move spring
bracket (2) to direction "a" and if it is lower, to direction "b" by
pushing spring bracket with a screw driver (3).
D Repeat steps 3) and 4) until rear brake pressure is within spec-
ification.
D After adjustment, be sure to torque screw (1) to specification.
Tightening Torque
.
(a): 5 N m (0.5 kg-m, 4.0 lb-ft)
5) Upon completion of fluid pressure test, bleed brake system and
perform brake test.
Rear brake
5,600 – 7,100 kPa
2
56 – 71 kg/cm
796 – 1,009 psi
pressure to front brake and
2
Rear brake
6,300 – 7,900 kPa
2
63 – 79 kg/cm
896 – 1,123 psi