Table of Contents
Advertisement
CHAPTER 9 MULTIFUNCTIONAL TIMER
[Bit 5]: STOP
This bit is used to stop the counter of the 16-bit free-run timer. When the bit is set to 1, the
counter of the timer is stopped. When the bit is set to 0, the counter of the timer is started.
0
1
Note:
When the 16-bit free-run timer is stopped, output compare operation is stopped as well.
[Bit 4]: MODE
This bit is used to set the initialization condition of the 16-bit free-run timer. When this bit is
set to 0, the counter value can be initialized by reset or with the clear bit (bit 3: CLR). When
the bit is set to 1, the counter value can be initialized by reset, with the clear bit (bit 3: CLR),
or by a match with the value of compare register 6 during an output compare operation.
0
1
Note:
The counter value is initialized when the counter value is changed.
[Bit 3]: SCLR
This bit is used to initialize the value of the operating 16-bit free-run timer to 0000
this bit is set to 1, the counter is initialized to 0000
returned value during the read operation is always 0. The counter value is initialized when
the counter value is changed.
SCLR
0
1
Note:
When initializing the counter value while the timer is stopped, set the data register to 0000
232
Allows counting (operation) (initial value)
Prohibits counting (stop)
Initialization by reset or the clear bit (initial value)
Initialization by reset, clear bit, or output comparison with compare register 6
This value has no effect. (initial value)
The counter value is initialized to 0000
. Setting this bit to 0 has no effect. The
H
Meaning of flag
.
H
. When
H
.
H
Advertisement
Table of Contents
