Prerequisites For Commissioning Cu305 With Canopen - Siemens Sinamics S110 Function Manual

Commissioning with CANopen
4.1 Requirements for commissioning
4.1.3

Prerequisites for commissioning CU305 with CANopen

To commission a CAN bus in a SINAMICS drive line-up,
the following hardware and software components are required:
● CU305 CAN with firmware in the non-volatile memory.
● Link between the CANopen Control Unit and a PC/programming device with an RS232
● The STARTER commissioning tool is installed on your PC/PG.
Note
Please see the SINAMICS S110 Equipment Manual for descriptions of the components of
a SINAMICS drive line-up as well as for information about wiring, the interface to a
PC/programming device, and the installation of the STARTER commissioning tool.
66
connection.
Function Manual, 10/2008, 6SL3097-4AB10-0BP0
Drive functions