Temperature Sensors For Sinamics Components - Siemens Sinamics S110 Function Manual

1.4

Temperature sensors for SINAMICS components

The following table provides an overview of the components which are available in
SINAMICS S110 with temperature sensor connections.
Table 1- 1 Temperature sensor connections for SINAMICS components
Module
SMC10/SMC20
SMC30
CU305
CU305
Cable for connection to direct measurement systems: Order number 6FXx002-2CB54-xxxx
1)
Commissioning information
The index [0..n] used in the following identifies either the motor data set or the encoder data
set.
SMC10/SMC20
The parameterization of the motor temperature evaluation via the sub D socket X520 can be
performed using the Starter screen (signals and monitoring \ Motor temperature).
SMC30
In addition to temperature evaluation via terminal X531 (temperature channel 1), this module
also has temperature evaluation at SUB-D socket X520 (temperature channel 2).
At the default setting (p0600 = 1 "Temperature via encoder 1" and p0601 = 20 "KTY") the
temperature is analyzed using the first temperature channel. The temperature sensor is
connected to terminal X531 on the SMC30. The temperature is shown via r0035.
Drive functions
Function Manual, 10/2008, 6SL3097-4AB10-0BP0
Interface Pin
X520 (sub D) 13
25
X520 (sub D) 1
Temperature 8
channel 2
X531 (terminal) 3
Temperature 4
channel 1
X133 (terminal) 7
Temperature
channel 1
8
X23 (sub D) 1
8
General information for commissioning
1.4 Temperature sensors for SINAMICS components
Signal name Technical specifications
+Temp Temperature sensor
- Temp KTY84/130 / PTC
+Temp Temperature sensor
- Temp KTY84/130 / PTC / bimetallic-
element switch with NC contact
- Temp Temperature sensor
+Temp KTY84/130 / PTC / bimetallic-
element switch with NC contact
+ Temp Motor temperature measurement
KTY84/130 (KTY+)
Temperature sensor connection
KTY84/130 / PTC
M (- Temp) Ground for KTY or PTC
+Temp Temperature sensor
- Temp KTY84/130 / PTC / bimetallic-
element switch with NC contact
33