Siemens Sinamics S110 Function Manual page 407

Bit Meaning
8 Speed
setpoint-actual value deviation
within tolerance band
9 Control request to PLC
10 f or n comparison value reached or
exceeded
Note:
The message is parameterized as follows:
p2141 Threshold value
p2142 Hysteresis
11 I, M or P limit reached or exceeded
12 Holding brake open
13 No motor overtemperature alarm
14 n_act >= 0
15 Alarm, drive converter thermal
overload
Drive functions
Function Manual, 10/2008, 6SL3097-4AB10-0BP0
1 Setpoint-actual value monitoring within tolerance
band
Actual value within a tolerance band; dynamic
overshoot or undershoot for t < t
e.g.
n = n ±
set
f = f ±, etc.,
set
t can be parameterized
max
0 Setpoint/actual value monitoring not within
tolerance band
1 Control requested
The PLC is requested to assume control. Condition
for applications with isochronous mode: drive
synchronized with PLC system.
0 Local operation
Control only possible on device
1 f or n comparison value reached or exceeded.
0 f or n comparison value not reached.
1 I, M or P limit not reached
0 I, M or P limit reached or exceeded
1 Holding brake opened
0 Holding brake closed
1 Motor overtemperature alarm not active
0 Motor overtemperature alarm active
1 Actual speed > = 0
0 Actual speed < 0
1 No alarm present
0 Alarm, converter thermal overload
The overtemperature alarm for the converter is
active.
Communication PROFIBUS DP
9.1 Communication according to PROFIdrive
Remarks
permissible,
max
BICO
BO: r2197.7
BO: r0899.9
BO: r2199.1
BO: r1407.7
BO: r0899.12
BO: r2135.14
BO: r2197.3
BO: r2135.15
407