Siemens Sinamics S110 Function Manual page 93

To start the ramp-function generator:
1. Meet the conditions for starting the ramp-function generator
2. Select the operating mode
3. Set the signal shape
4. Load the settings to the target system ("Download parameterization" button)
5. Start the ramp-function generator ("Start FctGen" button)
To stop the measuring function:
● "Stop FctGen" button
Parameterization
The "function generator" parameter screen is selected via the following icon in the toolbar of
the STARTER commissioning tool:
Figure 5-4
Drive functions
Function Manual, 10/2008, 6SL3097-4AB10-0BP0
– Activate the control panel
Drive_1 –> Commissioning –> Control panel
– Switch on the drive
Control panel –> Activate enable signals –> Switch on
e.g. speed setpoint downstream of filter
e.g. square-wave
STARTER icon for "trace function/ramp-function generator"
Diagnostics
5.2 Diagnostics via STARTER
93