Siemens Sinamics S110 Function Manual page 191

Upgrade the project
1. Is the project in STARTER? Yes: continue with 3.
2. Upload project with STARTER.
3. Install the latest firmware version for the project.
Update the firmware and load the new project to the target device.
1. Insert memory card with the new firmware version.
2. Go online and download the project to the target device -> Copy from RAM to ROM
3. Upgrading the firmware for the DRIVE-CLiQ components takes place automatically.
4. Reset the drive unit using a POWER ON (Control Unit and all DRIVE-CLiQ components).
Drive functions
Function Manual, 10/2008, 6SL3097-4AB10-0BP0
– Connect with target system (go online)
– Downloading the project into the PG
– in the project navigator, right-click the drive unit -> Target -> Device version
– e.g. select version "SINAMICS S110 V4.1x" -> Change version
– Disconnect the Control Unit from the power supply ->
– Insert the memory card containing the new FW version ->
– Power-up the Control Unit again.
The new firmware release is only effective in the DRIVE-CLiQ components now and is
also displayed in the version overview.
Drive functions
7.2 Basic functions
191