Figure 10-4
10.3
Commissioning with SINUMERIK Operate
10.3.1
Preconditions
For commissioning High Frequency Drive with SINUMERIK Operate, the following
preconditions must be met:
● The High Frequency Drive is connected to an NX module corresponding to the topology
rules (see DRIVE-CLiQ topology at the HF lineup (Page 158)).
● The High Frequency Drive is commissioned for the first time.
● The control line-up is switched on.
● The drive software is available in version 4.5 or higher.
High Frequency Drive
System Manual, (SH2), 04/2015, 6SL3097-4AH10-0BP3
DRIVE-CLiQ topology for one HF Drive 32 kHz (31.25 µs) with Active Line Module and
NX module
10.3 Commissioning with SINUMERIK Operate
Configuring
159