Basic Commissioning With Bop-2 - Siemens SINAMICS G120C Getting Started

Commissioning

4.1 Basic commissioning with BOP-2

4.1 Basic commissioning with BOP-2
The basic commissioning sets the most important data of the drive.
1.
2.
3.
4.
5,
6.
7.
8.
9.
10.
11.
22
The "SETUP" menu guides you step by step through the basic
OK
commissioning of the drive.
Select Reset if you wish to reset all parameters to the factory setting
OK
before the basic commissioning: nO → YES → OK
Select the motor control mode. The most important control modes
OK
are:
VF LIN
VF QUAD
SPD N EN
②
IEC or
OK
NEMA
standard
①
Voltage
OK
③
Current
OK
④
Power
OK
IEC (kW)
⑤
Power
NEMA (HP)
⑥
Speed
OK
We recommend the setting STIL ROT (Identify motor data at
OK
standstill and with the motor rotating).
If one of the following cases applies, select the setting STILL (identify
motor data at standstill):
 You have selected the "Speed control" control mode, but the
motor cannot rotate freely, e.g. for mechanically limited traversing
sections.
 You have set "V/f control" as control mode.
Select the configuration for the inputs and outputs, as well as the
OK
correct fieldbus for your application. The predefined configurations
can be found in the section titled Pre-defined interface configurations
(Page 14).
Set the minimum motor speed.
OK
Set the motor ramp-up time.
OK
V/f control with linear characteristic
V/f control with square-law characteristic
Closed loop speed control (vector control)
D-91056 Erlangen D-91056 Erlangen
3~Mot. 1LE10011AC434AA0 3~Mot. 1LE10011AC434AA0
IEC/EN 60034 100L IEC/EN 60034 100L IMB3 IMB3
25 kg 25 kg Th.Cl. 155(F) Th.Cl. 155(F) -20°C -20°C Tamb Tamb
Bearing Bearing UNIREX-N3 UNIREX-N3
DE DE 6206-2ZC3 6206-2ZC3 15g 15g
NE NE 6206-2ZC3 6206-2ZC3 11g 11g
60Hz: 60Hz: SF 1.15 CONT SF 1.15 CONT
V Hz A kW PF
400 50 3.5 1.5 0.73
690 Y 50 2.05 1.5 0.73
460 60 3.15 1.5 0.69
Set the motor data on the rating plate
Getting Started, 03/2012, FW V4.5, A5E03831830B AA
E0807/0496382_02 003 E0807/0496382_02 003
IP55 IP55
40°C 40°C
Intervall: 4000hrs Intervall: 4000hrs
NEMA NEMA MG1-12 MG1-12 TEFC TEFC Design A Design A 2.0 HP 2.0 HP
NOM.EFF NOM.EFF rpm V V
84.5% 84.5% 970 380 - 420 380 - 420 3.55-3.55 3.55-3.55
84.5% 84.5% 970 660 - 725 660 - 725 2.05-2.05 2.05-2.05
86.5% 86.5% 1175
SINAMICS G120C frequency converter
A A CL CL
K K