Avaya Definity SI Maintenance Manual page 961

ASAI-EPT
b. An endpoint is not responding to the service state query message sent to
the adjunct or to the endpoint. This error causes an alarm to be raised. The
alarm is retired when the switch receives a response to the service state
query to the endpoint or to the adjunct.
When this error occurs for an ASAI adjunct, the Aux Data field indicates the
state of the ASAI link and whether an invalid response or no response was
received to the query from the switch, as shown in the following table:
Aux Data
102
104
152
154
202
204
See "status bri-port" in Chapter 8 for an explanation of the ASAI link states.
For ASAI or Avaya adjuncts, the switch queries the adjunct every two
minutes. The Layer 3 Query Test is not executed for ASAI or Avaya
adjuncts through a command issued from the management terminal. While
alarmed for this error, the switch takes the associated port out-of-service
for five seconds every 15 minutes. This action attempts to stimulate
recovery actions to be taken by the adjunct.
When this error occurs for an ASAI or Avaya adjunct, the service technician
should:
1. Execute the test station extension command and perform the
2. Check the health of the adjunct by following the recommended
c. This error and associated warning alarm are logged against an ASAI
endpoint when the adjunct has asked the switch to suspend maintenance
on the ASAI endpoint. Busying out and releasing the ASAI station clears
this alarm.
d. This error occurs when the endpoint sends more messages than the switch
can handle. The switch suspends the reception of messages from the
endpoint for a short period of time. There is no repair procedure for this
error. If the condition persists, replace the endpoint.
e. This error occurs when the signaling link associated with the ASAI endpoint
has too much link-establishment related traffic. This occurs if the signaling
link is alternating between assigned and established states. If this problem
persists, replace the endpoint.
555-233-123
ASAI Link State
13-restarting
13-restarting
13-restarted
13-restarted
13-established
13-established
associated repair procedures for those tests.
repair procedures of the manufacturer of the adjunct if the preceding
step does not resolve the problem.
Error
No response to RESTART message
Invalid response to RESTART message
No response to Layer 3 query
Invalid response to Layer 3 query
No response to Layer 3 query
Invalid response to Layer 3 query
Issue 4 May 2002 10-175