Avaya Definity SI Maintenance Manual page 1411

DS1-BD (DS1 Interface Circuit Pack)
SAKI Sanity Test (#53)
This test is destructive. This test resets the circuit pack.
Table 10-233. TEST #53 SAKI Sanity Test
Error
Code Test Result
None ABORT
1005 ABORT
1015 ABORT
2100 ABORT
1 FAIL
555-233-123
Description/Recommendation
System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Wrong circuit pack configuration to run this test. This error
applies only to DS1 Interface circuit packs. It means the DS1
Interface circuit pack is providing timing for the system and,
therefore, it cannot be reset without major system disruptions.
1. If the circuit pack needs to be reset, then set
synchronization to another DS1 Interface circuit pack or
to the Tone-Clock circuit pack and try again. Refer to
"SYNC (Synchronization)".
Port is not out-of-service.
1. Busyout the circuit pack.
2. Execute the command again.
System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
The circuit pack failed to reset.
Continued on next page
Issue 4 May 2002 10-625