Avaya Definity SI Maintenance Manual page 1231

CO-TRK (CO Trunk)
c. ATMS test are not part of either sequence. They are run either on demand
with the test analog-testcall command or via the ATMS schedule.
Dial Tone Test (#0)
This test attempts to seize a port and checks for the return of a dial tone.
Table 10-165. TEST #0 Dial Tone Test
Error
Code
1000
1001
1002
555-233-123
Test
Result
ABORT Could not allocate system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT System resources required to run this test are not available.
The port may be busy with a valid call. Use the command
display port PCSSpp to determine the trunk group/member
number of the port. Use the status trunk command to
determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable for
certain tests. (Refer to the "Status Commands" section in
Chapter 10, "Maintenance Commands and Trouble-Clearing
Aids", for a full description of all possible states.) You must
wait until the port is idle before retesting.
1. If the port status is idle, then retry the command at
1-minute intervals a maximum of 5 times.
ABORT System resources required to run this test were not available.
This could be due to a failure to seize the port.
1. Retry the command at 1 minute intervals for a maximum of
5 times.
ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
TDM-BUS (TDM Bus) Maintenance documentation to
diagnose any active TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling
heavy traffic, repeat test at 1-minute intervals a maximum
of 5 times.
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-445