Avaya Definity SI Maintenance Manual page 815

ADX16D-P (16-Port AUDIX Digital Port)
Table 10-11. TEST #9 NPE Crosstalk Test
Error
Code
1
2
1000
1001
1002
555-233-123
Test
Result
ABORT During testing of the primary information channel, system
resources may not have been available. Also, the port may
have been busy during the test.
1. Check the port status (display port PCSSpp) to
determine the voice port extension of the port.
2. Use the status station command to determine the
service state of the port. If the port is in use, it is
unavailable for this test. Wait until the port is idle.
3. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
ABORT System resources may not have been available, or the port
may have been busy during the test.
1. Check if port is being used (status station).
2. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
ABORT System resources required to run this test are not available.
The port may be in use.
1. Use the display port PCSSpp command to determine
the voice port extension of the port.
2. Use the status station command to determine the
service state of the port. If the port is in use, it is
unavailable for certain tests. Wait until the port is idle
before testing.
3. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
ABORT System resources required to run this test are not available.
Try (a)
ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions, or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
"TDM-BUS" to diagnose TDM-BUS errors.
1. If system has no TDM-BUS errors, and if it is not handling
heavy traffic, retry the command at 1-minute intervals a
maximum of 5 times.
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-29