Avaya Definity SI Maintenance Manual page 1103

BRI-SET, ASAI-ADJ, BRI-DAT
Table 10-125. TEST #629 BRI Layer 3 Query — Continued
Error
Code
1187
2012
2100
2068
555-233-123
Test
Result
ABORT The circuit pack, port or station may have been busied out by a
technician.
1. Look in the Error Log for Error Type 18 (busied out) for
BRI-BD, BRI-PORT, or BRI-SET.
2. If this error type is present for BRI-SET only, then release
the station via the release station command.
a. If this error type is present for BRI-PORT and BRI-SET,
then release the port via the release port PCSSpp
command and run the test again.
b. If the error is present for BRI-BD, BRI-PORT, and
BRI-SET, then release the circuit pack via the release
port PCSSpp command and run the test again. If the
error is present for BRI-SET only, then release the
circuit pack via the release port PPCSS command and
run the test again. If the error is present for both
BRI-BD and BRI-PORT, then release the circuit pack
via the release board PPCSS command and run the
test again.
3. Make sure the terminal is connected.
4. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT Internal System Error.
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT The endpoint has rejected the switch sent application
message. This indicates that the endpoint does not support
the ISDN-BRI Management and Maintenance Procedure for
Endpoint Service Messages.
1. Use the change station extension command and
change the MIMs Supported? field to "no."
Description/Recommendation
NOTE:
When you release the circuit pack, you
release all ports associated with it. If certain
ports still need to be busied out, use the
release port PCSSpp command to busy
them out.
Continued on next page
Issue 4 May 2002 10-317