Release Spe-Standby - Avaya Definity SI Maintenance Manual

Maintenance Commands and Trouble-Clearing Aids

release spe-standby

The release spe-standby command removes busyout statuses of standby SPEs.
Memory shadowing restores, a memory refresh of the standby SPE occurs, and 1
minute later the equivalent of scheduled standby SPE maintenance returns the
standby SPE's Fault Severity Level to its appropriate value.
Standby SPE releases are allowed if communication to the standby is down.
Action/Object Qualifier
release
spe-standby
Feature Interactions
When standby SPEs release a memory, a refresh executes and the standby Fault
Severity Level lowers to its appropriate level. One minute later, the equivalent of
scheduled standby SPE maintenance executes and a spontaneous SPE
interchange might occur, depending of Fault Severity Levels of the two SPE's.
If the standby SPE is in poor health, memory shadowing must not enable
(communication to the standby is impossible, if it is enabled). Then the standby
SPE releases successfully.
Output
The following output example is a display of the release spe-standby command
and assumes that the standby SPE is located in carrier "B."
release spe-standby
Port Maintenance Name
01B STBY-SPE
Command successfully completed
Field descriptions
Port
Maintenance Name
Alt. Name
Result
Error Code
8-264 Issue 4 May 2002
Qualifier Description
SPE A
COMMAND RESULTS
Alt. Name Result
PASS
Port address displays the standby SPE's cabinet and carrier
location. (01A or 01B)
STBY-SPE
Not applicable. ()
Success status of a busied out object (PASS, ABORT, FAIL)
System-generated description of a command failure.
Logins Defaults
init none
inads
craft
Error Code
555-233-123
Feature
Interactions
see below