Atm-Intf (Tn2305/6) - Avaya Definity SI Maintenance Manual

ATM-INTF (TN2305/6)

ATM-INTF (TN2305/6)
MO Name (in
Alarm Log)
ATM-INTF
The TN2305/6 is recognized by the system as an ATM Interface board
(ATM-INTF) if it has not been assigned a personality through the add atm-pnc
command or add atm trunk command. ATM-INTF does not have a maintenance
strategy associated with it, although the Control Channel test can be run on
demand by using the test board command, and the board can be reset by using
the reset board command. The board is visible through the list config and
change circuit-pack commands.
The circuit packs listed in
to serve the ATM Port Network Connectivity (ATM-PNC).
Table 10-76. ATM-EI circuit packs for ATM-PNC
Circuit pack
TN2305
TN2306
NOTE:
Always replace an ATM-EI circuit pack with the same type.
LED states
The ATM-INTF circuit pack has the standard red, green and yellow LEDs. The red
and green LEDs have the traditional use: red indicates an alarm condition, green
means maintenance testing in progress. The yellow LED is not used. The possible
LED states are listed below:
LED
Red
Red
Green
Green
Yellow
Yellow
555-233-123
Alarm
Level Initial Command to Run
WARNING test board UUCSSpp
Table 10-76
Fiber
Multi mode
Single mode
Condition
Board is not healthy
Board is in the processes of booting
Maintenance is running tests on the
board
Fiber LOS
Signal to the ATM switch is down
Full Name of MO
ATM interface board
are ATM-EI boards if they are administered
Echo cancellation
Y
Y
LED
Solid on never off
Red: solid on
Green: 200 ms on 200 ms off
Solid on (off when
maintenance completed)
100 ms on, 100ms off
500 ms on, 500 ms off
Issue 4 May 2002
Release
7.1
7.1
10-211