Avaya Definity SI Maintenance Manual page 890

Maintenance Object Repair Procedures
Table 10-35. TEST #47 Loop Around and Conference Test — Continued
Error
Code
2000
2100
7
13
14
15
10-104 Issue 4 May 2002
Test
Result
ABORT Response to the test request was not received within the
allowable time period.
ABORT System resources required to run this test are not available.
Either a system allocation to get information about the port or
to put the port into a service state failed or the attempt to put
the port in connection with a tone source failed (this could be a
tone-clock problem). The tone-clock and tone detectors could
be having a communication problem, for example, the
companding modes could be out of synchronization.
1. Retry the command at 1-minute intervals a maximum of 5
times.
FAIL The conference test or the noise test failed. This could cause
noisy or unreliable connections, or users calling this port may
hear an echo. The problem can also be off-board, as described
below.
The reflective loop around with gain set to low and the
600-ohm balance failed. This will cause noisy or unreliable
connections.
The reflective loop around test (with the gain set to high, using
RC balance) failed. This could cause noisy or unreliable
connections. The problem can also be off-board, as described
below.
The nonreflective loop around test failed. This could cause
noisy or unreliable connections, or users calling this port may
hear an echo. The problem can also be off-board, as described
below.
More information continues on the next page.
Description/Recommendation
Continued on next page
555-233-123