Avaya Definity SI Maintenance Manual page 954

Maintenance Object Repair Procedures
Aux Data Error Codes and Recommended Repair
Procedures
Table 10-55. Aux Data Error Codes and Recommended Repair Procedures
Aux
Data
9000
through
9031
30001
through
30054
32001
32002
32003
32004
32005
10-168 Issue 4 May 2002
Description/Recommendation
CARD-MEM [386 systems] errors.
Check and resolve CARD-MEM [386 systems] errors and alarms.
Tape [286 systems] errors.
Check and resolve TAPE [286 systems] errors and alarms.
Internal system error.
1. Check other ANNOUNCE errors and take corrective action. If there
are no other ANNOUNCE errors, do the following:
2. Retry the command at two minute intervals a maximum of three times.
3. If the save/restore announcements command fails, escalate the
problem.
Announcement circuit pack is in use.
1. Retry the command at two minute intervals a maximum of three times.
2. If the save/restore announcements command fails, escalate the
problem.
Announcement port is in use.
1. Wait for all Announcement ports to become available.
2. Enter the save/restore announcements command.
There are no announcements recorded on the Announcement Circuit
Pack. The save announcements command is not allowed to prevent the
destroying of the announcement file on tape [286 systems] or on the
memory card [386 systems].
Integrated announcement circuit pack is not present. The Announcement
Circuit Pack is not inserted, or it is defective.
1. Enter the list config command to check for the presence of the circuit
pack in the system.
2. If the Announcement Circuit Pack is present, use the test board
PCSS command to check the status of the Announcement Circuit
Pack.
Continued on next page
555-233-123