Avaya Definity SI Maintenance Manual page 1209

CO-DS1 (DS1 CO Trunk)
Table 10-159. TEST #6 NPE Crosstalk Test
Error
Code
1000
1001
1002
1003
555-233-123
Test
Result
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT System resources required to run this test were not available.
The port may be busy with a valid call. Use the display port
PCSSpp command to determine the trunk group/member
number of the port. Use the status trunk command to
determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable for
certain tests. You must wait until the port is idle before
retesting.
1. If the port status is active but the port is not in use (no
calls), check the error log for error type 1025 (see the error
log table for a description of this error and required
actions). The port may be locked up.
2. If the port status is idle, retry the command at 1-minute
intervals for a maximum of 5 times.
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out-of-service due to TDM-BUS errors. Refer to the
TDM-BUS (TDM Bus) Maintenance documentation to
diagnose any active TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling
heavy traffic, repeat test at 1-minute intervals a maximum
of 5 times.
ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present or some tone detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to TTR-LEV (TTR Level) Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer
to TONE-PT (Tone Generator) Maintenance
documentation.
3. If neither condition exists, retry the test at 1-minute
intervals a maximum of 5 times.
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-423