Dig-Bd (Digital Line Circuit Pack); Dig-Ip-Stn (Digital Ip Station) - Avaya Definity SI Maintenance Manual

DIG-BD (Digital Line Circuit Pack)

DIG-BD (Digital Line Circuit Pack)
MO Name (in
Alarm Log)
DIG-BD
DIG-BD
1 Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier
designation (for example, A, B, C, D, or E); and SS is the address of the slot in the
carrier where the circuit pack is located (for example, 01, 02, etc.).
Refer to XXX-BD (Common Port Circuit Pack) Maintenance documentation for
circuit pack level errors. See also DIG-LINE (Digital Line) Maintenance
documentation for related line information.

DIG-IP-STN (Digital IP Station)

MO Name (in
Alarm Log)
DIG-IP-STN
The Softphone has some level of existing DCP maintenance in the form of audits,
and updates. In addition, it also has error log entries and test to clear values.
In addition this MO covers a new Avaya Voice terminal that communicates to the
switch via an IP LAN. This type of terminal, referred to as an IP Phone is made up
of the 46XX line of terminals. This terminal emulates DCP signaling carried over
TCP.
This station type is not attached to a port board. Insertion of the station is not
driven by board insertion, rather it is driven by successful registration of the
endpoint. It is maintained via a set of explicit TCP/IP ping requests and errors
reported by the User Manger software, which terminates the H.323 signaling
portion of each endpoint. The MO follows standard maintenance methodology
and supports test, busyout, release and status commands.
Maintenance for Softphone includes Error Log Entries and Test to Clear Values.
See table DIG-IP-STN Digital IP Station Error Log Entries.
555-233-123
Alarm
Level Initial Command to Run
MIN test board PCSS sh
WRN test board PCSS sh
Initial Command to
Alarm Level Run
WARNING test station extension
1
Full Name of MO
Digital Line Circuit Pack
Digital Line Circuit Pack
Full Name of MO
Digital IP Station
Issue 4 May 2002 10-551