Avaya Definity SI Maintenance Manual page 880

Table of Contents

Advertisement

Maintenance Object Repair Procedures
Battery Feed Test (also called Port Diagnostic
Test) (#35)
The battery feed chip provides power to the telephone equipment, signaling,
rotary dial pulsing, transmission, and balance. This test checks the signaling and
switchhook capabilities of the battery feed chip by terminating the port, applying
battery, and trying to detect a current.
Table 10-33. TEST #35 Battery Feed Test
Error
Code
Result
ABORT
1000
ABORT
1004
ABORT
1005
ABORT
10-94
Issue 4 May 2002
Test
Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
System resources required to run this test are not available. The
port may be busy with a valid call. Use the display port PCSSpp
command to determine the station extension. Use the status
station command to determine the service state of the port. If the
service state indicates that the port is in use, then the port is
unavailable for certain tests. You must wait until the port is idle
before retesting.
1. If the port status is idle, then retry the command at 1-minute
intervals a maximum of 5 times.
System resources required to run this test are not available. The
port may be busy with a valid call. Use the display port PCSSpp
command to determine the station extension. Use the status
station command to determine the service state of the port. If the
service state indicates that the port is in use, then the port is
unavailable for certain tests. You must wait until the port is idle
before retesting.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort and the port is not in use,
escalate the problem.
The test was aborted due to a configuration problem. This code
will result under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to
terminal equipment other than a voice terminal (for example,
the modem pool member or music on hold).
2. The circuit pack is one of the following:
— TN742 vintages 13,14 and 15
— TN769 vintages 3,4 and 5
Description/Recommendation
Continued on next page
555-233-123

Advertisement

Table of Contents
loading

Table of Contents