Test Card-Mem - Avaya Definity SI Maintenance Manual

Maintenance Commands and Trouble-Clearing Aids

test card-mem

This command executes a sequence of tests on the memory card in the specified
switch processor element. The test sequences in order for both long and short
options are listed in the following table:
Test
Memory Card Insertion Test (#695)
Memory Card Format and Read Test (#696)
Memory Card Match Test (#697)
Memory Card Write-Protected Test (#698)
Memory Card Directory Recovery Test (#699)
Memory Card Translation Data Integrity Test (#694)
Memory Card Erase/Write/Read Test (#693)
Memory Card Capacity Test (#1014)
Flash Data Consistency Test (#421)
1If the directories match, this test runs normally. If the directories do not match, this test
attempts to correct the mismatch, and if the flash card is an old 12V flash card, the attempt
at correction fails.
2This test fails with old 12V cards, although those cards can indeed be read.
3The "Flash Data Consistency Test" is not executed in simplex systems.
These tests verify the sanity of the memory card device, the basic
read/erase/write operations to the memory card, the integrity of the translation
data stored in the memory card, the function of 12 volt power supply in TN777B
NETCON circuit pack used for memory card erase/write operations, the
translation capacity of the memory card, and the consistency of data stored in
both memory cards in a High or Critical Reliability system. This command can
also help troubleshoot the following hardware errors: CARD-MEM, CAP-MEM,
and FL-DATA.
8-422 Issue 4 May 2002
Short Long
X X
X X
X X
X X
1
X X
X
2
X
X
3
X
555-233-123