Avaya Definity SI Maintenance Manual page 1294

Maintenance Object Repair Procedures
NPE Crosstalk Test (#6)
The NPE Crosstalk Test verifies that this port's NPE channel talks on the selected
time slot and never crosses over to time slots reserved for other connections. If
the NPE is not working correctly, one-way and noisy connections may be
observed. This test is usually part of a port's Long Test Sequence and takes about
20 to 30 seconds to complete.
Table 10-186. TEST #6 NPE Crosstalk Test
Error
Code
1000
1001
1002
1003
10-508 Issue 4 May 2002
Test
Result
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT System resources required to run this test are not available.
The port may be in use on a valid call. Use status
data-module to determine when the port is available for
testing.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1minute intervals a maximum of 5
times.
ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
"TDM-BUS" to diagnose TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling
heavy traffic, repeat test at 1-minute intervals a maximum
of 5 times.
ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present or some Tone Detectors may be out-of-service.
1. Resolve any "TTR-LEV" errors.
2. Resolve any "TONE-PT" errors.
3. If neither condition exists, retry the test at 1-minute
intervals a maximum of 5 times.
Description/Recommendation
Continued on next page
555-233-123