Avaya Definity SI Maintenance Manual page 1307

DID-DS1 (DS1 DID Trunk)
Hardware Error Log Entries and Test to Clear
Values
Table 10-192. DID-DS1 Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 (a) Any
15 (b) Any Port Audit and
Update Test (#36)
18 (c)
130 (d) None
257 (e) 57474
57473
513 (f) 57392 None
769 (g) 57393 None
1281 Conference Circuit
Test (#7)
1537 NPE Crosstalk Test
(#6)
1793
(h)
2305(i) 50944 None
3840 Port Audit and
(j) Update Test (#36)
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
2 This alarm will only be raised when the System-Parameter Country form has the Base Tone
Generator field set to 4 (Italy). This alarm will be a MINOR alarm unless 75% or more trunks in this
trunk group are out of service, then the alarm will be upgraded to a MAJOR alarm.
3 Minor alarms on this MO may be downgraded to Warning alarms based on the values used in the
set options command. If the Minor alarm is not downgraded by the set options values, the Minor
alarm is upgraded to a Major alarm if 75 percent of the trunks in this trunk group are alarmed.
Notes:
a. DS1 Interface circuit pack detects a hardware error. The Aux Data field
contains the Error Type: 57476, on-hook before wink; 57477, on-hook
before ready to receive digits; 57485, wink too short for valid signal.
Escalate the error.
555-233-123
Alarm On/Off
Level Board
Any Any test trunk <grp>/<mbr> sh r 1
WARNING OFF release trunk <grp>/mbr>
WARNING ON test trunk <grp>/<mbr>
2
MIN/MAJ OFF
2
MIN/MAJ OFF
MAJ/MIN/ ON test trunk <grp>/<mbr> l
3
WRN
MAJ/MIN/ ON test trunk <grp>/<mbr> l
3
WRN
ON test board PCSS l
2
MIN/MAJ OFF
Issue 4 May 2002
Test to Clear Value
Continued on next page
10-521