Avaya Definity SI Maintenance Manual page 923

ANN-BD (Announcement Circuit Pack)
Table 10-44. Announcement Circuit Pack Error Log Entries — Continued
Error Aux
Type Data
2561
17676
2817(l)
17682
17699
(m)
3840(n) Any
3999(o) Any
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
!
WARNING:
Announcement board alarms are upgraded to MAJOR when the BASE Tone
Generator is set to 12. (France).
Notes:
a. Error Type 1
physically removed from the system.
If the circuit pack is not in the system, insert a circuit pack (in the same slot
as the error indicates) to resolve this error. Or, if the circuit pack is in the
system and the red LED is on, follow the instructions for "Red (alarm)" in
the "Control and Port Circuit Pack Status Led" section in Chapter 7, "LED
Interpretation".
555-233-123
Alarm Level
Associated (See WARNING
Test
Super Frame MINOR
Match Inquiry
Test (#211)
In-line Error
Announcement MINOR
Checksum Test
(#209)
In-line Error
In-line Error
None
None

The circuit pack totally stopped functioning or it was
NOTE:
The alarm is logged about 11 minutes after the circuit pack has been
removed and/or SAKI Test (#53) fails.
NOTE:
The alarm is logged about 11 minutes after the circuit pack has been
removed and/or SAKI Test (#53) fails.
On/
Off
below) Board
ON test board PCSS sh r 3
ON test board PCSS sh r 3
Continued on next page
Issue 4 May 2002
Test to Clear Value
10-137