Avaya Definity SI Maintenance Manual page 834

Maintenance Object Repair Procedures
Table 10-18. TEST #6 NPE Crosstalk Test — Continued
Error
Code
1003
1004
1005
1018
2000
2100
10-48 Issue 4 May 2002
Test
Result
ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of tone detectors
present or some tone detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to "TTR-LEV".
2. Look for TONE-PT errors in the Error Log. If present, refer
to "TONE-PT".
3. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT The port was seized by a valid call during the test. The test
has been aborted. Use the display port PCSSpp command
to determine the station extension. Use the status station
command to determine the service state of the port. If the port
is in use, wait until the port is idle before testing.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT The test was aborted due to a configuration problem. This test
may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the
modem pool member or Music On Hold).
ABORT The test has been disabled by administration. The default for
the Test field on the station form is y. Determine why this field
has been set to n on this station (this may be due to the
ringing application test 48, that can be customer or terminal
disturbing).
1. To enable the test for a particular station being tested,
enter change station extension and set the Test? field
on the station from n to y.
ABORT Response to the test request was not received within the
allowable time period.
ABORT System resources required to run test are not available. This
could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Description/Recommendation
Continued on next page
555-233-123