Avaya Definity SI Maintenance Manual page 910

Maintenance Object Repair Procedures
Table 10-41. Test #36 Station Status and Translation Audits and Updates
Error
Code
2100
1
5
7
10-124 Issue 4 May 2002
— Continued
Test
Result Description/Recommendation
ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals no more than 5
times.
2. If the test continues to abort, escalate the problem.
FAIL The switchhook audit failed. This result does not indicate a
hardware problem. The other updates were not performed
because of this failure. This may occur if the audit is
performed at the same time the terminal equipment goes
off-hook.
1. Use the status station extension command to
determine when the port is available.
2. Retry the command at 1-minute intervals no more than 5
times.
3. If the test continues to fail, escalate the problem.
FAIL The message waiting lamp update failed. This may be an
internal software error. The translation and ringer updates
were not performed because of this failure.
FAIL The translation update failed. There may be an internal
software error. The ringer update was not performed because
of this failure.
Continued on next page
555-233-123