Avaya Definity SI Maintenance Manual page 817

ADX16D-P (16-Port AUDIX Digital Port)
Voice and Control Channel Local Loop Test (#13)
This test checks the information and control channels between the Switch
Processing Element (SPE) and the EMBEDDED AUDIX port circuit. The SPE
sends a message to loop around both the information and control channels for the
port. First, the primary information (voice) channel loop back test is run.
While the primary information channel is still looped around, the Control Channel
Loop Around Test is performed. The Loop Around Test for the secondary
information (data) channel is then performed. This test is the same as the primary
information channel loop around test.
Next, a Conference Test is implemented for the primary information channel. This
test is the same as Conference Test #6.
Only one value (Pass, Fail, or Abort) is generated as a result of the four tests run.
If any test fails or aborts, the sequence is stopped.
Table 10-12. TEST #13 Voice and Control Channel Local Loop Test
Error
Code
1000
1001
555-233-123
Test
Result
ABORT Internal System Error
1. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
ABORT System resources required to run this test are not available.
The port may be in use.
1. Use the display port PCSSpp command to determine the
voice port extension of the port.
2. Use the status station command to determine the
service state of the port. If the port is in use, it is
unavailable for certain tests.
3. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
ABORT System resources required to run this test are not available.
1. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-31