Avaya Definity SI Maintenance Manual page 876

Maintenance Object Repair Procedures
Table 10-32. TEST #6 NPE Crosstalk Test — Continued
Error
Code
1003
1004
1005
1018
10-90 Issue 4 May 2002
Test
Result
ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present or some Tone Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to "TTR-LEV (TTR Level)" Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer
to "TONE-PT (Tone Generator)" Maintenance
documentation.
3. If neither condition exists, retry the test at 1-minute
intervals a maximum of 5 times.
ABORT System resources required to run this test are not available.
The port may be busy with a valid call. Use the display port
PCSSpp command to determine the station extension. Use
the status station command to determine the service state of
the port. If the service state indicates that the port is in use,
then the port is unavailable for certain tests. You must wait
until the port is idle before retesting.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort and the port is not in use,
escalate the problem.
ABORT The test was aborted due to a configuration problem. This
code will result under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to
terminal equipment other than a voice terminal (for
example, the modem pool member or music on hold).
2. The circuit pack is one of the following:
— TN742 vintages 13,14 and 15
— TN769 vintages 3,4 and 5
ABORT Test disabled via administration. The default for the 'Test' field
on the 'Station' form is 'y'; thus, you may want to determine
why this field has been set to 'n' on this station (this may be
due to the ringing application test 48, which can be customer
or terminal disturbing).
1. To enable the test for a particular station, enter change
station extension and set the 'Test?' field on the 'Station
Form' to 'y.'
Description/Recommendation
Continued on next page
555-233-123