Avaya Definity SI Maintenance Manual page 1366

Maintenance Object Repair Procedures
DIG-LINE Station Lamp Updates Test (#16)
This test lights all lamps on the terminal as specified. The lamp updates will run
only if the station is in-service. The status of the station is checked and the lamp
updates are blocked from taking place if the station is not in the in-service state.
This test does not affect the status of the Message Waiting lamp.
Table 10-215. TEST #16 DIG-LINE Station Lamp Updates Test
Error
Code
1
3
1000
10-580 Issue 4 May 2002
Test
Result
ABORT Internal System Error
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT This port may have been busied out by system technician.
1. Look in the Error Log for Error Type 18 (port busied out) for
this port. If this error type is present, then release the port
via the release station <extension> command and run
the test again.
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT Station may be in ready-for-service or out-of-service state.
1. Use status station command to verify state of station.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT System resources required to run this test are not available.
The port may be busy with a valid call. Use display port
PCSSpp to determine the station extension or attendant
number of the port. Use status station or status attendant to
determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable for
certain tests. You must wait until the port is idle before
retesting. Attendants are always in use (off-hook) if the handset
is plugged in and the port is not busied out.
1. If the port status is idle, then retry the command at
1-minute intervals a maximum of 5 times.
Description/Recommendation
Continued on next page
555-233-123