Avaya Definity SI Maintenance Manual page 1029

ATM-TRK (Circuit Emulation Service Circuit Pack)
Table 10-96.
Error
Code Result
2000 ABORT
2100 ABORT
2500 ABORT
FAIL
PASS
0 NO
BOARD
Packet Interface Loop Around Test (#598)
This nondestructive test checks the ATM-TRK circuit pack's packet-bus interface.
The LANHO chip sends data through the bus and back to itself.
describes this test, substituting "CES mode" for "PNC mode."
If the data received is consistent with the data sent, the test passes. The test does
not run if the packet bus in the specified port network has a minor alarm, or is out
of service, or if the packet bus in the PPN is out of service.
555-233-123
Control Channel Test #52
Test
Test request timed out.
Could not allocate needed system resources.
Internal system error
Retry the command up to 3 times at 1-minute intervals.
The ATM circuit pack responded incorrectly.
Retry the command up to 3 times at 1-minute intervals.
If the test continues to fail, reset the ATM-TRK circuit pack (reset
board UUCSS).
If test continues to fail, replace the circuit pack or transceiver.
The ATM-TRK circuit pack is communicating correctly with the
software.
Circuit pack not detected.
Check the error log for Error 125 (wrong board) or Error 131 (no
board), and correct any errors found.
Make sure that the ATM-TRK circuit pack is properly translated
and inserted.
Check for Error 1538 (hyperactivity). If hyperactive, run reset
board UUCSS.
Run the test again. If it fails, replace the ATM-TRK circuit pack,
and retest.
Description/Recommendation
Issue 4 May 2002
Continued on next page
Table 10-151
10-243