Set Synchronization - Avaya Definity SI Maintenance Manual

set synchronization

set synchronization
This command sets DS1 trunks or active tone/clock circuit packs that supply
references for synchronization. The set synchronization command works after
the disable synchronization command disables synchronization. Technicians
may administer DS1 trunks or active tone/clocks with the set synchronization
command. DS1 or tone/clocks remain synchronization references until the set
synchronization command runs with another board or until the enable
synchronization command runs.
After the enable synchronization command runs, administered primary or
secondary synchronization sources become synchronization references. If no
primary or secondary source is administered, synchronization uses active
tone/clock boards as synchronization references after synchronization is enabled.
The synchronization subsystem provides error-free digital communication
between the switch and other PBXs, COs, or customer premise equipment.
System components involved in synchronization include: TDM bus clock, DS1
trunk board, maintenance and administration software resident in the SPE.
Action/Object Qualifier
set location
synchronization
555-233-123
Qualifier Description
Physical location: PCsspp (DS1 trunk
or active tone/clock) that supplies a
synchronization reference.
Examples:
set synchronization 01c08
set synchronization 02a01
set synchronization 01a
set synchronization 02c
Feature
Logins Defaults Interactions
init none none
inads
craft
Issue 4 May 2002 8-293