Tips & Tricks, Settings; Operating From A Local Station With Two Remote Stations - Siemens Gigaset M 101 Data Operating Instructions Manual

Tips & tricks, settings
Tips & tricks, settings

Operating from a local station with two remote stations:

Teilnehmer 1
2
Basis
Basis
1
Basis
2
1
Basis
2 3
24
This section describes settings, implementation options and
programming methods.
Please note that
Only one connection can be active.
Only one "Teilnehmer" station type can be registered at a
base that is ready for registration.
The station type for Gigaset M101 Data units is set to "Basis"
by default.
Perform registration as described in the section "Initial configu-
ration" on page 11.
COM
The Gigaset unit connected to the PC is called "Gigaset 1" and
is the lokale Station. It is now an Teilnehmer station type and
your Gigaset 2 (Partnerstation) is a Basis. Configure the trans-
mission parameters that are required for a connection between
Gigaset 1 and Gigaset 2.
3
Change to the Local station tab and click Change station type,
your Gigaset 1 is now a base.
COM
Exit the configuration program and connect Gigaset 3 to the
COM port.
3
Now start the "Gigaset M101 Data > Set Gigaset" configuration
program and switch to the Local station tab. Click Change sta-
tion type. Gigaset 3 is now an "Teilnehmer".
Press the black button on Gigaset 1 (station type currently Ba-
sis) for 10 s. The LEDs start to blink alternately, the base is ready
for registration.
COM
Teilnehmer Click Register, enter the PIN (factory default "0000") and click
OK. You have now registered Gigaset 3 (as an extension) at
Gigaset 1 (the base).
Configure the transmission parameters that are required for a
connection between Gigaset 3 and Gigaset 1. Exit the configu-
ration program.
Connect Gigaset 1 to the COM port at the PC that you want to
use for bothway operation.