Snmp Com2Sec; Snmp Group - Siemens S223 User Manual

Siemens single-board fast ethernet switch operators user manual
Table of Contents

Advertisement

UMN:CLI
7.1.3
7.1.4
106

SNMP Com2sec

SNMP v2 authorizes the host to access the agent according to the identity of the host and
community name. The command, com2sec, specifies the mapping from the identity of
the host and community name to security name.
To configure an SNMP security name, use the following command.
Command
snmp com2sec SECURITY
{IP-ADDRESS | IP-ADDRESS/M}
COMMUNITY
no snmp com2sec SECURITY
show snmp com2sec
The following is an example of configuring SNMP com2sec.
SWITCH(config)# snmp com2sec TEST 10.1.1.1 PUBLIC
SWITCH(config)# show snmp com2sec
Com2Sec List
SecName
---------------------------------------
com2sec
TEST
SWITCH(config)#

SNMP Group

You can create an SNMP group that can access SNMP agent and its community that be-
longs to a group.
To create an SNMP group, use the following command.
Command
snmp group GROUP { v1 | v2c |
v3 } SECURITY
no snmp group GROUP { v1 | v2c
| v3 } SECURITY
show snmp group
Mode
Specifies the mapping from the identity of the host and
community name to security name, enter security and
community name.
SECURITY: security name
Global
COMMUNITY: community name
Deletes a specified security name, enter the security
name.
SECURITY: security name
Enable
Shows a specified security name.
Global
Source
Community
10.1.1.1 PUBLIC
Mode
Creates SNMP group, enter the group name.
GROUP: group name
SECURITY: security name
Global
Deletes SNMP group, enter the group name.
GROUP: group name
Enable
Shows a created SNMP group.
Global
SURPASS hiD 6615 S223/S323 R1.5
Description
Description
A50010-Y3-C150-2-7619
User Manual

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S323Surpass hid 6615 s223Surpass hid 6615 s323 r1.5

Table of Contents