Assigning Device To Control On/Off Status Of The Backlight - Mitsubishi Electric F920GOT-K Hardware Manual

GOT-F900 SERIES (CONNECTION)
23.1.2

Assigning Device to Control ON/OFF Status of the Backlight

The backlight ON/OFF status can be controlled by setting to ON or OFF the backlight control device set
in the screen creation software by a sequence program.
1) In the case of screen creation software (GT Designer2)
Operating procedure Tool menu
In the sequence program example shown below, the read device is set to "D10".
D10 b1: Backlight control
(When this bit is set to ON, the backlight will turn off after the specified time.)
Read device (system signal 1)
b15 b14
For the details of the system information, refer to the GOT-F900 OPERATION MANUAL (GT
Designer2) or the manual of the screen creation software.
M8000 (RUN monitor)
When a data file created using the DU/WIN is used (only in the GOT-F900) or when the data is read
from the GOT-F900, execute the following procedure.
Operating procedure Tool menu
A sequence program example is equivalent to the example shown for the DU/WIN later.
Select "Common"-"System Environment".
Click "System Information" in the tree displayed on the "System
Environment" dialog box, then set "Read Device".
Tree in the project work space
Double-click "Common"-"System Environment".
Click "System Information" in the tree displayed on the "System
Environment" dialog box, then set "Read Device".
b13 b12 b11 b10
M11
MOV K3M10 D10
Select "Common"-"System Environment".
Click "Interface Device" in the tree displayed on the "System Environment"
dialog box, then set "Bit Device".
Tree in the project work space
Double-click "Common"-"System Environment".
Click "Interface Device" in the tree displayed on the "System Environment"
dialog box, then set "Bit Device".
b9 b8 b7 b6 b5
ON = Extinguished/OFF = Lit
M21 to M10→D10
Appendix 23
b4 b3 b2 b1 b0
Backlight control
23-3
21
22
23