Mitsubishi Electric F920GOT-K Hardware Manual page 310

GOT-F900 SERIES (CONNECTION)
[Change method] Change the connection type of the already created data as follows.
- The "PLC type" selection item display varies depending on the software version as follows.
GT Designer
Version
Connection setting
availability
*1 Available choices on the menu are changed to "A SERIES" and "QnA, Q SERIES".
Operation
In the case of SW4D5C-GOTR-PACKE earlier than version A,
perform the setting in the GOT-F900.
(Set the connection in "CONNECTION" in the GOT-F900.)
For the setting method, refer to "1) GOT-F900 Series" on the
previous page.
e)Set the following.
Port : RS-422
RS-232C
Type : CPU
DST Station No. (Station No.) : 0
GOT Station No. (−)
In the case of F943 Handy GOT
Without regard to the port setting (RS-422 or RS-232C), the
COM0 side of the RS-232C is fixed for PLC connection.
Combinations of "Port" and "Type" are as follows.
Connection destination
Direct connection to Q CPU
Computer link unit for Q
Computer link unit for Q
a)Open GT Designer.
b)Click the [Open] button.
c)Open (read) the screen data to be changed.
d)On the menu, select "Common"-"GOT/PLC Type".
- For the contents of setting, refer to c) of [Creation] above.
- For selection of the RS-422 or the RS-232C on the Q Series
PLCs, refer to e) of [Creation] above.
"PLC type" selection item display in GT Designer
MELSEC-A MELSEC-A, QnA
SW1-A or later SW2-A or later
Not available Not available
Connection of MELSEC-Q Series PLC 11
: −
Port Type
RS-232C
CPU
RS-422
MELSEC-A
MELSEC-QnA, Q
SW4-F or later
Available
(Select "MELSEC-QnA,Q".)
Display (screen name)
The "Select Project"
dialog box appears.
The "GOT/PLC Type"
dialog box appears.
MELSEC-A
*1
MELSEC-QnA, Q
MELSEC-Q (Multi)
SW5-P or later (5.13P)
Available
(Select "QnA, Q SERIES"
or "Q (MULTI) SERIES".)
11-20