Mitsubishi Electric F920GOT-K Hardware Manual page 428

GOT-F900 SERIES (CONNECTION)
5) In the case of CPM2C Series (CPU equipped with built-in peripheral port)
In the CPU CPM2C-10CDR-D, write data to the data memory (DM) shown in the table below using a
peripheral tool. In the CPU CPM2C-10CDR-D, set the DIP switch shown below.
Setting item
CPM2C-10CDR-D
DIP switch SW1
The table below explains the data memory (DM) Nos. and set values which should be set using a
peripheral tool.
Setting item
Communication
Transmission speed
Transmission delay time
Unit number
No protocol
communication
Connection of SYSMAC C Series PLC (Manufactured by Omron) 15
Set value
OFF
Port Set value (hexadecimal)
DM6645 0001H
DM6646 0304H
DM6647 0000H
DM6648 0000 to 0031
DM6649 0000H
Remarks
Remarks
Communication condition: Set individually
Host link mode
CTS control: Not provided
Baud rate: 19200 bps
Start bit length: 1 bit
Data length: 7 bits
Stop bit length: 2 bits
Parity: Even
Transmission delay time: 0ms
Host link unit number (BCD value)
Default (effective according to no protocol.)
15-16