Mitsubishi Electric F920GOT-K Hardware Manual page 96

GOT-F900 SERIES (CONNECTION)
Caution on setting of "Lamp (External)"
1. The contents of "Lamp (External)" you have set are not displayed on the screen.
2. The setting of "Lamp (External)" is valid only in the F920GOT-K, F930GOT-K and Handy GOT.
Never set it in any other series.
3. Set only one lamp for all screens of the created screen data.
4. Make sure that the bit device assigned on the "Basic" tab in "Lamp" dialog box is not included in
the read/write device range set in "Common"-"System Information".
Function key setting
1. "Available Operation Panel" check box is valid only in the F920GOT-K, F930GOT-K and Handy
GOT. Do not set it in any other series.
2. Several boxes displayed on the "Operation Panel" dialog box (shown in the table below)
correspond to the function keys. Note that key codes cannot be set to the function keys though
the contents of operation setting are equivalent to those for touch switches.
Setting up the function keys (for the F920GOT-K)
The function keys in the F920GOT-K are assigned as shown below.
F920GOT-K
Setting up the function keys (for the F930GOT-K)
The function switches in the F930GOT-K are assigned as shown below.
F930GOT-K
7 8
4 5
1 2
0 -
Installation and Wiring of F920GOT-K/F930GOT(-K)/F940(W)GOT 4
"Operation Panel" dialog box
Check this box ( ).
"Operation Panel" dialog box
9
ESC
SET $
6
3
DEV
ENT
Check this box ( ).
"*" indicates that a function is set.
$
$
F1~F6
"*" indicates that a function is set.
F1~F8
4-26