Mitsubishi Electric F920GOT-K Hardware Manual page 404

GOT-F900 SERIES (CONNECTION)
[Change method] Change the connection type of the already created data as follows.
Setting the transmission specifications for microcomputer connection
[Creation]
Operation
In the case of SW4D5C-GOTR-PACKE earlier than version A,
perform the setting in the GOT-F900.
(Set the connection in "CONNECTION" in the GOT-F900.)
For the setting method, refer to "1) GOT-F900 Series" on the
previous page.
e)Set the following.
Port : RS-422
RS-232C
Type : CPU
DST Station No. (Station No.) : 00 (01 to 31 when two or more
GOT Station No. (−)
a)Open GT Designer.
b)Click the [New] button.
c)Open (read) the screen data to be changed.
d)On the menu, select "Common"-"GOT/PLC Type".
- For the contents of setting, refer to c) of [Creation] above.
- For selection of the RS-422 or the RS-232C on the
Microcomputer, refer to e) of [Creation] above.
Set the transmission specifications consecutively.
Operation
a)On the menu, select "Common"-"Auxiliary Setting"-"Project"-
"Serial Port".
b)Set the transmission specifications set in the microcomputer.
Set "Speed", "Parity", "Data Bit" and "Stop Bit".
(Handshaking not available)
GOTs are connected)
: −
↓ ↓ ↓ ↓
Connection of Microcomputer 14
Display (screen name)
The "Select Project"
dialog box appears.
The "GOT/PLC Type"
dialog box appears.
Display (screen name)
The "Project Auxiliary
Settings" dialog box
appears.
14-28